Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable Air Duct Cleaning Across Studio City
Air duct cleaning in Studio City typically runs between $450 and $900 for a full residential system, and the work takes four to seven hours depending on the home’s size and duct configuration. CleanRun has served Studio City homeowners since 2013 with a simple operating rule: a written price before any panel comes off, and a camera-recorded look inside every duct run before and after the work. If you’re researching because the house smells like old dust every time the AC kicks on, or because Santa Ana winds just dragged another round of ash through the canyon, call (806) 606-6902 and we’ll walk you through what’s actually involved.
We know Studio City’s streets from Fryman Canyon to Carpenter School, and more importantly we know what’s inside the ductwork of its 1940s ranch homes and hillside contemporaries. That local familiarity means we don’t quote you blindly over the phone. We ask the right questions about your home’s age, layout, and exposure, then give you a number that holds.
Why CleanRun Air Duct Cleaning Is Studio City’s Preferred Air Duct Cleaning Company
Most Studio City homeowners call us after a specific event: a nearby brush fire left ash drifting through the neighborhood, a remodel stirred up decades of drywall dust, or a new HVAC system exposed how much debris sat in the old duct runs. By the time we arrive, the homeowner has usually looked at three or four company websites and is tired of vague promises. Our approach is different because our evidence is visible. Every job ends with a Documented Photo Record showing the interior of each duct run, before and after, delivered to you as a standard part of the job. Tomas Reyes, who owns CleanRun, made that a rule from day one: no claim about cleanliness that we cannot show you on camera.
We’re also the company Studio City calls when another contractor already left a mess. That’s not flattery; it’s our incoming call log. Hillside homes above Ventura Boulevard often hide non-standard duct routing from remodels, and crews unfamiliar with the area routinely skip return ducts near the air handler because they’re hard to reach. We don’t skip them. We open them, camera them, and show you what’s inside.
Our Air Duct Cleaning Services in Studio City
Residential Duct Cleaning
Studio City’s flatlands hold a dense inventory of 1940s through 1960s ranch homes and post-war bungalows, many with original metal ducts that predate modern sealing standards. Residential cleaning here means more than running a vacuum hose through the registers. We use Rotobrush agitation tools paired with negative-pressure extraction to break loose the decades of chaparral dust, deteriorated liner fragments, and construction debris that settle in disconnected joints. Every run gets photographed, including the runs the prior company may have skipped.
Supply Duct Cleaning
Supply ducts push conditioned air into your rooms, and in Studio City’s heat-trap climate they work overtime from June through October. Central HVAC here runs 30 to 45 percent longer than coastal Los Angeles systems, which means more air moving through the same duct surfaces, more debris accumulation, and faster degradation of old liner materials. We clean the full length of each supply run, from the plenum at the air handler to the register grille, and we verify clear sightlines with a camera inspection before we consider the job done.
Return Duct Cleaning
Return ducts are where Studio City homes show their age. On a hillside street above Fryman Canyon Road, our techs opened a mid-century custom home’s return duct and found a thick layer of ash and fire-retardant residue from the 2019 Getty Fire still caked inside. We ran a Rotobrush agitation tool with HEPA-filtered negative pressure to pull the combustion particles out of the supply and return runs, then verified clear sightlines with a camera inspection-no fogging needed, just source removal. That’s a pattern we see repeatedly in canyon-mouth homes: returns act as collection points for whatever the Santa Anas push through the building envelope.
Video Inspection
Every CleanRun job in Studio City includes video inspection before and after cleaning. We don’t ask you to take our word for the debris load; we show you the footage on-site. The camera goes into the plenum, the duct runs, and the return drops. What we find shapes what we do. If we see disconnected sections, we tell you. If we see evidence of pest intrusion, we tell you. The photo record you receive is the same record we use to sign off on the job.
BeforeAfterTrusted Brands We Service in Studio City
We work on systems from every major manufacturer and clean with equipment from Rotobrush, Nikro, and Guardsman. That matters for two reasons. First, our negative-pressure units are sized for the debris load we actually encounter in Studio City’s canyon-mouth homes, not the light household dust a flatland crew in Van Nuys might design around. Second, our agitation tools throw enough force to dislodge baked-on ash without damaging old metal ducts. If you have a specific equipment question before booking, call (806) 606-6902 and ask. We’ll tell you what we’ll use and why.
Common Air Duct Cleaning Problems We See in Studio City Homes
- Wildfire ash and combustion residue. Studio City sits at the mouth of Fryman, Coldwater, and Laurel Canyons, where Santa Ana winds funnel wildfire ash and chaparral particulate directly into duct systems. We’ve opened returns years after a fire season and found layers of gray ash still attached to duct walls.
- Deteriorated liner and loose fiberglass fragments. Many 1940s and 1950s systems were lined with materials never designed for 70 years of service. In Studio City’s prolonged heat, those liners break down and shed particles into the air stream. Cleaning removes the loose material, but we’ll also flag ducts that need repair or sealing.
- Disconnected joints and air leakage. Hillside homes with remodels often have duct sections that were never properly rejoined, leaving gaps where unfiltered attic air can enter. We find more disconnected sections per job in Studio City hillside homes than anywhere else in the Valley.
- Fire-retardant residue and pink chemical traces. Homes above Fryman Canyon Road that were near fire suppression drops often show pink or orange chemical staining inside return ducts. These residues cling to duct surfaces and require mechanical agitation to remove, not a fogger.
Pricing for Air Duct Cleaning in Studio City, CA
A full residential system in Studio City generally runs $450 to $900. Smaller single-story ranch homes with four to eight runs fall on the lower end; hillside contemporaries with non-standard routing, multiple returns, and hard-to-access sections land higher. The biggest cost variable is access: if your home requires crawlspace or attic work to reach the full duct system, the labor increases accordingly. CleanRun gives a written price per system before work starts, not per vent. No per-vent math, no bait-and-switch coupon, no surprise line items once the panel is off. If you already have a written estimate from another company, bring it to us and we’ll give you a free second opinion on it, in writing.
What you pay for is the extraction. We use HEPA-filtered negative pressure and mechanical agitation to remove the material inside your ducts. We don’t charge extra for the camera inspection or the before-and-after photo record; those are standard deliverables on every job since 2013.
We Also Serve Cities Near Studio City
Our crews work throughout the surrounding area, including North Hollywood, Universal City, Van Nuys, and West Hollywood. If you’re outside Studio City proper, ask whether your neighborhood falls within our standard service radius. You can also read more about our full coverage area on the Air Duct Cleaning in Studio City service page.
Serving Studio City, CA - Our Local Coverage Area
We’re based in the Studio City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Air Duct Cleaning in Studio City
The only reliable way is visual inspection with a camera. Ash from the Getty Fire and other Mulholland-area burns persists inside ductwork for years, especially in return runs where airflow slows and particles settle. If you live near Fryman Canyon Road, Coldwater Canyon Avenue, or Laurel Canyon Boulevard and have never had your ducts inspected after a major fire season, the odds are high. We include video inspection on every job, so you’ll see what’s in there before we clean it. Call (806) 606-6902 to schedule an inspection and get a written price for any necessary work.
Because the duct geometry and the debris load are different. Hillside homes above Ventura Boulevard often have non-standard routing added during remodels, with return ducts that climb through attics or jog around beams. Flatland Valley crews using undersized negative-pressure units cannot pull debris through those tight, convoluted runs effectively. CleanRun crews size equipment for the job and never skip a return duct just because it’s hard to reach. The difference is visible in the after-video.
No, and paying for one before removing the ash layer can make things worse. Foggers introduce moisture into ducts. If there’s still a layer of dry ash and fire-retardant residue on the duct walls, that moisture turns the ash into a paste that can harden and clog blower components. The correct sequence is source removal first: mechanical agitation plus HEPA-filtered negative pressure to pull the combustion particles out of the duct system. We don’t sell fogging as a duct cleaning substitute, and we’ll tell you as much in writing if you ask. If you have questions about what’s actually in your ducts, call (806) 606-6902.
Yes, as long as the duct bodies themselves are structurally sound. Rotted seals and loose joint connections are common in Studio City’s original ranch homes, and cleaning around them requires care. Our techs assess each run before applying agitation, avoiding weakened sections that could collapse under pressure. After cleaning, we’ll show you where the seals failed and recommend repair or sealing if needed. The Duct Repair & Sealing part of our service exists precisely for these older Studio City systems.
A good filter protects the air handler and reduces incoming particles, but it doesn’t clean anything already inside the ductwork. By the time you move into a 60-year-old Studio City home, the ducts have already accumulated decades of debris from prior occupants, remodels, and fire seasons. The filter is a gate, not a janitor. Cleaning addresses what’s already past the gate and bonded to the duct walls. If your system has never been cleaned and the home predates 1980, a camera inspection is the fastest way to see whether cleaning is justified. Call (806) 606-6902 and we’ll schedule it.
Call CleanRun for Air Duct Cleaning in Studio City
If your home sits at the mouth of Fryman, Coldwater, or Laurel Canyon, the ducts are carrying more than household dust. We’ll open the system, show you what’s inside on camera, give you a written price before work starts, and clean it properly. You’ll receive a Documented Photo Record of every duct run, the work is backed by our 365-Day Done Right Promise, and you’ll never pay a surprise line item. Call (806) 606-6902 for a free estimate.
Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning, serving Studio City since 2013.
Air Duct Cleaning in Nearby Areas
