Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable HVAC Cleaning Across Arlington
HVAC cleaning in Arlington, MA typically runs between $390 and $720 for a full system clean, depending on the number of units, the condition of the coil, and whether the duct runs need sealing afterward. We work in Arlington every week, and we know these houses: they’re older, well-built, and full of ductwork that’s been moving air for decades. If you suspect your system is blowing dust, or your energy bills have crept up while airflow has dropped, call (806) 606-6902 and we’ll put a written price in front of you before any panel comes off.
Why CleanRun Air Duct Cleaning Is Arlington’s Preferred HVAC Cleaning Company
We’ve spent years inside Arlington attics and mechanicals. What we find there is consistent: original flex duct from the 1970s through the early 1990s, trunk lines running through unconditioned spaces, and evaporator coils that haven’t felt a brush in years. Our HVAC Cleaning team approaches every Arlington job the same way: camera first, written scope second, work third. You see the before photos. You see the after photos. You decide what matters.
Customers in Arlington call us because we document what we find. When a homeowner near the Brackett School asks whether their coil was actually cleaned, we show them the photo record from inside the air handler. Not a summary. The image. That’s been our practice since 2013, and it’s part of the 365-Day Done Right Promise: if the work isn’t right, we make it right, in writing.
Response time to Arlington is consistent: most cleanings are scheduled within a few business days, and we tell you the arrival window before the truck leaves. No races, no countdowns. Just a crew that knows the streets east of Massachusetts Avenue, the condominium towers along the Mystic River, and the triple-deckers near Arlington Center, and shows up ready to work.
Our HVAC Cleaning Services in Arlington
Evaporator Coil Cleaning
The evaporator coil in an Arlington home does the actual cooling. When it’s coated with matted dust and biological film, the system runs longer to hit the thermostat, and indoor humidity stays high all summer. We remove the access panel, document the condition, clean the coil with professional-grade products, and treat it to slow re-fouling. In the brick-veneer ranches east of Collins Street, we frequently find coil fins clogged with a paste of dust and condensed attic heat.
Blower Cleaning
The blower wheel moves air past a clean coil and through your ducts. If the wheel’s blades are packed with debris, airflow drops even after the coil is clean. We pull the blower assembly, photograph it, and clean each blade. In Arlington homes where the blower hasn’t been serviced in a decade, this alone can restore airflow you’d written off as a weak system.
Condenser Cleaning
The outdoor condenser on an Arlington lot deals with pollen, cottonwood, mower clippings, and the fine dust that blows through North Texas every spring. Coated condenser coils drive compressor temperatures up, and compressors are expensive. We clean the coil, straighten bent fins, and check the refrigerant lines for obvious problems before we leave. A clean condenser means a cooler house for the same electricity.
Air Handler Cleaning
The air handler is the box where the coil, blower, and filter meet. In Arlington’s older subdivisions, these units often sit in unconditioned attics where 140°F heat breaks down internal insulation and adhesives. We clean the entire interior, inspect the drain pan and line, and note any insulation shedding. If the drain line is clogged, we clear it. If the insulation is degrading, we tell you and give a written price to address it.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Service in Arlington
We clean and service equipment from the brands Arlington homeowners actually have, including Honeywell, Rotobrush, Nikro, and Guardsman. Our techs are trained on the equipment we use, not a rented machine from a hardware store. If you have a Trane, Carrier, Lennox, or Goodman system, we work on it. If you have a Honeywell media filter housing, we inspect and clean it as part of the job. We carry common filters and drain-line components on the truck, which means fewer follow-up visits for Arlington customers.
Common HVAC Cleaning Problems We See in Arlington Homes
- Crushed or disconnected flex runs. In subdivisions south of I-20, the original flex duct running through 140°F attics has compressed or pulled loose at the trunk line, pulling attic air and insulation fiber into the supply stream. Cleaning helps, but sealing or replacing the failed run is the actual fix.
- Crumbled flex-duct inner liners. The older subdivisions along the eastern corridor near the Grand Prairie border often have galvanized trunk lines with flex branch runs whose inner liners have turned to dust. The result: white flakes at the registers every time the blower runs.
- Post-Uri contamination. Winter Storm Uri forced systems across Arlington to run at maximum capacity for days. The pressure differentials pulled outdoor debris, and in some cases attic rodent activity, into ductwork that had never been opened. A routine cleaning without camera inspection misses these pockets.
- Pollen-loaded coils and blowers. Arlington sits in the Southern Plains pollen corridor. Mountain cedar in the winter, oak and grass in the spring. The coil and blower wheel act as the filter’s last line of defense, and by May they’re often caked.
Pricing for HVAC Cleaning in Arlington, MA
We write the price before we start. CleanRun’s Haven Standard Clause 1 says a written price is delivered before any work begins, every time. No exceptions. A full system clean for a typical Arlington single-family home runs $390 to $720. If we find failed flex sections or a disconnection that requires replacement, that’s quoted as a separate line item, in writing, before the work continues. No bill shock, no bait-and-switch. You’ll know the number before a single panel comes off. Call (806) 606-6902 for a written estimate.
We Also Serve Cities Near Arlington
Our HVAC cleaning crews also cover Belmont, Medford, Cambridge, and Watertown. If you’re in Arlington or a neighboring town and your system is pushing dust, call us at (806) 606-6902. We’ll tell you what it costs, in writing, before any work begins.
Serving Arlington, MA - Our Local Coverage Area
We’re based in the Arlington area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - HVAC Cleaning in Arlington
Because your ductwork is older, and it lives in a hotter attic. Most Arlington ranches were built between 1970 and 1995 with original flex duct now 30 to 50 years old. Flex-duct liners degrade in the 140°F attic heat, and the adhesive at trunk-line connections breaks down. Add Arlington’s high pollen loads from mountain cedar and oak, and you have a system that accumulates debris faster than a newer house with modern duct materials. We recommend a camera inspection every three to five years for homes in this age bracket. Call (806) 606-6902 if you’ve never had one.
Crushed runs, disconnected runs, and degraded inner liners. We worked a brick-veneer ranch east of Collins Street in a subdivision south of I-20 where the original flex branch runs to three bedrooms had inner liners crumbled from decades of thermal cycling. The camera showed fiberglass shedding at every register. We performed full source removal with HEPA-filtered negative pressure, then sealed the trunk-line connections and replaced the failed flex sections before rebalancing airflow at each supply register.
Cleaning alone won’t stop it if the flakes come from inside the duct liner. In Arlington homes where the inner liner of flex duct has crumbled, cleaning removes the loose particles, but the liner continues to shed. The fix is a combination: clean the system, then seal or replace the failed flex sections. If you’re seeing white flakes at registers, call us at (806) 606-6902. We’ll camera-inspect the run and show you exactly what’s happening.
In Arlington’s pollen seasons, we typically see measurable buildup on the coil and blower within 12 to 18 months, even in homes with good filtration. Mountain cedar hits December through February, oak and grass run March through May. If your system lacks a media filter, the buildup is faster. We recommend an annual filter check and a camera inspection every two to three years. You’ll see the before and after photos each time.
It depends on what the camera finds. If the duct runs are intact and the liner is holding, cleaning is worth doing. If the liner has crumbled or the run is collapsed, cleaning buys you a few weeks before the same debris returns, and replacement is the only real fix. We’ll show you the camera images and give you a written price for either path. You decide. Call (806) 606-6902 for a written estimate.
Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning, serving Arlington since 2013.