Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable HVAC Cleaning Across Frisco
HVAC cleaning in Frisco typically means removing years of construction debris, pollen, and compacted dust from your ductwork, coils, and blower assembly. Most Frisco homes were built between 2000 and 2022, and nearly all of them share one thing: builder-grade flex ducts that were never cleaned after drywall crews finished. If you’re in Frisco and haven’t had your system opened up since the day you moved in, there’s a good chance the inside looks worse than you’d expect. Call us at (806) 606-6902 and we’ll give you a written price before any panel comes off.
We know Frisco’s street grid, its master-planned subdivisions, and the construction timeline that defines most of the housing stock here. That local knowledge matters because a home in Miramonte built in 2006 has a very different duct profile than a home in Phillips Creek Ranch built in 2019. Our HVAC Cleaning team has worked both, and the difference is usually visible on camera within the first three feet of the first return duct.
Key Takeaways for Frisco Homeowners
- Homes built during Frisco’s 2000-2010s boom almost always carry drywall dust and spray-foam overspray in the ducts from day one.
- Frisco HVAC systems run nearly continuously from late April through early October, baking that debris onto coils and blower wheels.
- Whole-system HVAC cleaning in Frisco typically runs $450 to $900, depending on home size and system configuration.
- You get a written price before work starts, and a photo record of every duct run when we finish.
Why CleanRun Air Duct Cleaning Is Frisco’s Preferred HVAC Cleaning Company
We started in 2013 with a rule: written price before any work starts, and a documented photo record when the job is done. That rule has held through tens of thousands of homes, and it’s the reason Frisco homeowners tend to call us first when they want to know exactly what’s inside their ducts, not just a promise that we cleaned them.
Our crews work in Frisco neighborhoods every week, from The Trails to Lawler Park to the newer builds east of the Dallas North Tollway. When we open a plenum in a 2008-era home off Stonebrook Parkway, we already know what we’re likely to find. That’s not a guess. It’s pattern recognition built from years of camera inspections in this specific housing stock. Tomas Reyes, who leads our team, reviews the before-and-after record on every Frisco job personally.
Every technician is background-checked, uniformed, and identified by name before we ever set foot inside your home. That’s Haven Standard Clause 3: Verified Crews. It’s written into the same document as our pricing rule and our warranty. You can read it on paper before you agree to anything.
BeforeAfterOur HVAC Cleaning Services in Frisco
Evaporator Coil Cleaning
The evaporator coil sits inside the air handler and wrings moisture out of the air as it cools. In Frisco, that coil is wet for months at a time because the system runs so hard from April through October. Construction dust that was never removed from the ducts gets pulled across that wet coil and bakes on in layers. A typical evaporator coil cleaning in Frisco runs $150 to $300. We photograph the coil before and after, and the difference is usually stark.
Air Handler Cleaning
The air handler is the big metal box in your attic or closet that houses the coil, the blower, and sometimes the heat strips. In Frisco’s two-story homes, that unit often sits in an unconditioned attic where it gets hot enough to fuse fine dust to internal surfaces. We open the cabinet, vacuum the interior, clean the drain pan, and document the entire cavity. Air handler cleaning in Frisco generally runs $200 to $400 depending on access and condition.
Blower Cleaning
The blower wheel is what pushes conditioned air through your ducts. When debris builds up on the blades, the wheel gets heavier and less efficient. In a Frisco summer, that means longer runtimes and higher electric bills before the motor prematurely gives out. Blower cleaning is typically $100 to $200 as part of a full system clean. Our technicians use negative-pressure extraction with brands like Rotobrush and Nikro so debris doesn’t blow back into the plenum while we work.
Condenser Cleaning
Your condenser is the outdoor unit, and Frisco’s active construction sites keep a fine layer of dirt and particulate in the air constantly. Coils on the outside unit clog with grass clippings, cottonwood, and construction silt. A condenser cleaning in Frisco usually runs $100 to $175. We’ll show you a photo of the coil before we rinse it and after. The temperature drop across the coil is measurable on the spot.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Frisco
We work on systems from every major manufacturer, and we stock common replacement parts and cleaning media for Trane, Carrier, Lennox, Goodman, Rheem, and American Standard units that dominate Frisco’s housing stock. When a coil treatment is needed, we use professional-grade products from Honeywell and Guardsman, applied according to manufacturer specifications. That means no generic spray-bottle shortcuts. If you want to verify what’s being used before you agree to the price, we’ll show you the containers.
Common HVAC Cleaning Problems We See in Frisco Homes
- Post-construction debris left in flex ducts: Builders don’t clean ducts at handover. Drywall dust, insulation particles, and spray-foam overspray sit in the flex runs from day one, and most homeowners assume a new house means clean ducts. The debris stays for 10 to 20 years.
- Baked-on debris on coils from continuous runtime: Frisco systems run hard from late April through early October. That sustained heat and humidity turns fine dust into a hard, insulating layer on the evaporator coil that reduces airflow and raises runtime.
- Shared duct problems across entire subdivisions: When one builder puts up 80 homes in 14 months, the same subcontractors install the same undersized return chases and builder-grade duct board. Systems in that neighborhood clog on roughly the same schedule, which means a clean on one street is a strong predictor of what the neighbors will find.
- Pollen-dense return air compounding the buildup: Frisco sits in a high-pollen corridor with mountain cedar in winter, oak in spring, and ragweed in fall. That pollen enters through return-air intakes and mixes with existing construction dust to create a dense, matted layer inside the ducts.
Pricing for HVAC Cleaning in Frisco, TX
Whole-system HVAC cleaning in Frisco typically runs $450 to $900. That includes the duct cleaning, air handler cleaning, blower cleaning, and evaporator coil cleaning. A standalone coil cleaning runs $150 to $300. A standalone blower cleaning runs $100 to $200. Condenser cleaning runs $100 to $175. Your written price depends on square footage, number of zones, access to the attic unit, and how long the system has gone without service.
What doesn’t change is this: the price we put in writing before work starts is the price you pay. That’s Haven Standard Clause 1, and it applies to every Frisco job. No surprise line items. No per-vent add-ons. One flat price per system, agreed before the first panel comes off. Call us at (806) 606-6902 for a free estimate with a photo record included.
We Also Serve Cities Near Frisco
If you’re in Frisco or one of the surrounding communities, our crews cover the full corridor. We regularly work in Little Elm, The Colony, Denton, and Lewisville. The same written-price guarantee and documented photo record apply on every job, no matter which side of the tollway you’re on.
Serving Frisco, TX - Our Local Coverage Area
We’re based in the Frisco area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - HVAC Cleaning in Frisco
Yes. A 2018 build has had seven years of runtime with the same construction debris it received at handover. Builders don’t clean ducts before you move in. Drywall dust, insulation particles, and spray-foam overspray entered the system during construction and have been cycling through your air handler ever since. The fact that the home feels new is exactly why nobody has looked inside yet. Call (806) 606-6902 and we’ll show you the camera feed before we do anything else.
A hardened base layer of fine drywall dust, usually compressed under years of HVAC lint. In homes built during the 2000s, we also routinely find spray-foam overspray, blown-in insulation particles, and occasionally drywall screws or wire clippings that fell into open registers during framing. The same subdivisions show the same signature because the same crews did the work. Our camera records it all before we remove a single pound of it.
They make the debris mix stickier. Mountain cedar, oak, and ragweed pollen are all fine enough to pass through a standard filter, and when they land on a coil that’s already coated in six years of construction dust, they form a dense mat that restricts airflow. That mat can hold moisture, which accelerates coil corrosion. A system in Frisco needs more frequent cleaning than a system in a city with shorter cooling seasons, simply because it runs more hours per year and sees more inhalable particulate per cubic foot.
Yes, in most cases. We use negative-pressure extraction equipment from Rotobrush and Nikro that connects directly to the ductwork, and we access the air handler through its service panels. The blower wheel generally comes out for a proper cleaning, but the air handler cabinet stays in place. Access matters in Frisco, because many attic units are wedged into tight corners with short clearances. We’ll assess that before starting any work and note it in the written scope.
Almost certainly. Entire Frisco subdivisions were framed and ducted by the same subcontractors within the same 12 to 18 month window. Our technicians consistently find an identical debris signature across homes in the same development, down to the same undersized return chases and the same builder-grade flex duct that starts to delaminate around year 12. A clean on one street is a reliable predictor of what the next house down will look like on camera. Call (806) 606-6902 and we’ll put a written price in front of you before we unroll a single hose.
Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning, serving Frisco since 2013.
HVAC Cleaning in Nearby Areas
