Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable HVAC Cleaning Across Inglewood
HVAC cleaning in Inglewood means removing the gray, gritty paste that accumulates inside duct runs when LAX jet exhaust and Hollywood Park construction dust mix with marine-layer humidity. A full system cleaning for a typical post-war Inglewood home runs $450-$850, and the work includes source removal inside every accessible duct run, the air handler, blower motor, and evaporator coil. We photograph the inside of your ducts before and after so you can verify what was actually removed. Call (806) 606-6902 to get a written price before any work begins.
Why CleanRun Air Duct Cleaning Is Inglewood’s Preferred HVAC Cleaning Company
Inglewood homes present a set of ductwork conditions we don’t see anywhere else in the South Bay. The combination of LAX arrival corridors directly overhead and the multi-year Hollywood Park grading work off Prairie Avenue has produced a dust signature that’s visibly different from anything in Hawthorne or Culver City. It’s gritty, gray, and packed into return-air ducts even in homes with fresh filters. We know what that means, and we know what actually removes it.
Our HVAC Cleaning crews work throughout Inglewood weekly, from the tree-lined streets off Arbor Vitae to the newer renovations near downtown. Tomas Reyes founded CleanRun in 2013 with a single rule that still governs every job: a written price before any panel comes off. No per-vent math, no upsell after the van pulls up. Haven Standard Clause 1. The 365-Day Done Right Promise backs every job in writing, not in a marketing line.
Our HVAC Cleaning Services in Inglewood
Air Handler Cleaning
Your air handler is where the marine layer does its worst work. Coastal humidity settles into the blower cabinet, and when it mixes with construction dust drawn in from the Century Boulevard corridor, it forms a paste that coats the housing, the blower wheel, and the wiring. We open the handler, photograph it, and remove the buildup manually before running negative-pressure extraction. This is not a fog-and-go service. The handler gets cleaned, not misted.
Evaporator Coil Cleaning
In Inglewood’s older bungalows, the evaporator coil often sits in a closet or a cramped attic space where it’s never been touched since installation. The coil collects the same gray paste that lines your ducts, and because coil fins run wet during cooling cycles, the debris turns into a damp mat that reduces airflow and feeds mold growth. We clean the coil with professional-grade cleaners and rinse it properly, then photograph the before and after so you can see the surface come back. A coil that looks clean when it isn’t costs you cooling performance every month.
Blower Cleaning
A blower motor packed with Hollywood Park dust and coastal moisture has to work harder to move the same air. That means higher energy use and a motor that may fail years early. We remove the blower, clean each blade, inspect the motor windings, and photograph the assembly before reinstalling. If the motor is already failing, we’ll show you why and give you a written scope for replacement. No pressure, just documentation.
Condenser Cleaning
The outdoor condenser in Inglewood sits in salty air and collects a film that inland units never see. Jet exhaust residue from overhead flights settles on the coil fins, and the nightly marine layer keeps it damp. We wash the condenser coil with the right cleaner, straighten bent fins where needed, and clear the surrounding area so airflow stays unrestricted. This is part of a full system clean, not an add-on we pitch at the door.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Service in Inglewood
We service and clean equipment from Honeywell, Aprilaire, and Guardsman, among other trade-recognized manufacturers. Our crews carry the professional-grade tools to match: Rotobrush and Nikro extraction systems with HEPA filtration, plus Abatement Technologies equipment for jobs where older ductwork requires containment. When a part needs replacing, we source it properly and install it under the same written-price rule as every other job. You’ll know the brand, the part number, and the price before we begin.
Common HVAC Cleaning Problems We See in Inglewood Homes
- Gray paste in return-air ducts. We pull this from homes along the Century and Prairie corridor constantly. The dust is fine enough to pass through standard MERV filters, and it accumulates in the return duct because that’s where the air moves slowest. In a 1950s tract home, this paste can build to a quarter inch within a couple of years.
- Mold and mildew inside debris-laden duct runs. The June Gloom marine layer pushes moisture into older duct systems that never fully dry between cycles. Once the gray paste gets wet, it becomes a food source. A cheap brush-and-vac job removes surface dust but leaves the damp biofilm behind, and the smell returns in weeks.
- Asbestos-containing tape on original sheet-metal ducts. Homes built between the 1940s and mid-1960s often have asbestos-bearing tape and wrap insulation at every seam. We inspect with a camera before any aggressive agitation, because disturbing that material improperly can release friable fibers into the living space. This is exactly why a real cleaning in Inglewood starts with an assessment, not a spinning brush.
- Blower motors caked with construction dust. The fine dust from Hollywood Park grading works its way into the blower housing and coats the wheel and motor windings. We’ve seen motors burn out years early because the insulation layer trapped heat. Cleaning the blower is preventive, and it’s part of our standard system clean.
Pricing for HVAC Cleaning in Inglewood, CA
A full HVAC cleaning in Inglewood typically runs $450-$850 for a single system in a post-war bungalow or small tract home. Larger homes with multiple returns or zone dampers run $650-$1,100. Air handler cleaning alone is $180-$320. Evaporator coil cleaning is $150-$280 when done as part of a full clean. These are whole-system prices, agreed in writing before work starts. You are not paying per vent, and we don’t bait you with a low number and inflate it on site. The price we write is the price you pay. Call (806) 606-6902 and we’ll give you a fixed number after we understand your system, not a range stretched to fit whatever the van finds.
We Also Serve Cities Near Inglewood
Beyond Inglewood, our crews work regularly in Hawthorne, Culver City, Lawndale, and Manhattan Beach. Each of those cities has its own micro-conditions, but none of them sit directly under the LAX approach path the way Inglewood does. That local knowledge matters when we’re making recommendations about how often your system needs attention.
Serving Inglewood, CA - Our Local Coverage Area
We’re based in the Inglewood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - HVAC Cleaning in Inglewood
That gray grit is the signature of ultrafine particles from LAX jet exhaust and years of Hollywood Park construction dust. Standard MERV filters are not designed to intercept particles at these volumes and sizes. The dust passes through the filter, enters the return-air stream, and settles where air velocity drops. A monthly filter change helps, but it cannot stop this specific dust load from accumulating inside your ductwork. The fix is source removal, which is what our negative-pressure extraction process does. Call (806) 606-6902 for a written price.
It can be safe, but only if the technician checks for asbestos-containing tape and wrap insulation first. Homes built between the mid-1940s and mid-1960s in Inglewood commonly have this material at duct seams. We inspect with a camera before any aggressive agitation, and if asbestos materials are present, we adjust our method to avoid disturbing them. Skipping this step can turn an air-quality job into an abatement emergency. Every CleanRun job starts with this assessment because the building stock in Inglewood demands it.
The marine layer pushes humid air into your duct runs every night, and that moisture gets absorbed by whatever debris is already inside. When the debris gets wet, mold and mildew bloom, and the smell circulates through the house the next time the system kicks on. The rest of the house may be dry because it’s open and ventilated, while the inside of your ductwork stays damp and dark for weeks. Real source removal eliminates the food source, and the smell does not return. A fogging sanitizer alone just wets the debris further, and the odor comes back once the fog dissipates.
Yes. We open the air handler, photograph the blower wheel and motor, and inspect the bearings and windings. Construction dust coats the blades and throws the wheel out of balance, which sounds like a low rumble or a whistle that changes pitch. A worn motor bearing sounds like a high-pitched squeal or a grinding noise that gets worse over time. The distinction matters because cleaning fixes the first problem and cleaning will not fix the second. We show you the photos and explain what we found before recommending any work. If the motor is the issue, you get a written scope and price for replacement.
Yes, and it’s more urgent in Inglewood than in nearby cities because the LAX ultrafine particles coat the coil fins and mix with the coil’s condensation to form a damp, sticky film. That film insulates the coil, reduces heat exchange, and promotes mold growth. An evaporator coil in an Inglewood home that hasn’t been cleaned in five years is likely running at reduced efficiency even if the rest of the system looks okay. Coil cleaning as part of a full HVAC cleaning runs $150-$280. Call (806) 606-6902 for an exact number in writing.
Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning, serving Inglewood since 2013.