Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Guardsman Dryer Vent Cleaning in New York City: What to Know First
Guardsman dryer vent cleaning in New York City typically runs $189-$389 for a full-system clean, depending on vent run length and how much lint has compacted at the elbows. We’re an independent Guardsman service provider - not affiliated with the manufacturer - and we complete most single-family vent cleanings in one visit, with a written price before any panel comes off. This page is for homeowners who own a Guardsman-branded dryer or live in a building where Guardsman vent components were installed, and who want the vent system cleaned without the usual bait-and-switch. Call (806) 606-6902 for a written quote.
How Guardsman Products Fail - and How We Fix Them
Guardsman components in New York City apartments and townhouses fail in predictable ways. Here’s what we see week over week, based on the documentation from thousands of camera inspections:
- Compacted lint at the first vertical elbow. On Guardsman rigid vent runs installed in pre-1990 buildings - common in Astoria, Woodside, and the Upper East Side - the first 90-degree elbow after the dryer traps more lint than the rest of the run combined. The camera typically shows a 2 to 3-inch build-up at that point, reducing airflow to about a third of spec. We run a negative-pressure extraction through the full run and photograph that elbow before and after, so you can see the difference in your own ductwork.
- Corroded vent caps on Guardsman wall terminations. New York City’s salt air and freeze-thaw cycles eat through the thin galvanized caps Guardsman installs on exterior wall terminations within four to six years. We replace them with heavier-gauge aftermarket caps that meet Guardsman’s vent diameter specs, and we document the old cap with a photo before removal. The replacement doesn’t void any dryer warranty - the cap is a vent system component, not a dryer part.
- Disconnected Guardsman flex transition behind the dryer. The semi-rigid Guardsman transition hose (often the Guardsman Flex-Connect line) disconnects at the dryer collar when the machine gets pushed back against the wall during cleaning or appliance swaps. The result is hot, humid air dumping into the laundry closet behind the machine. We reconnect with a proper clamp, replace the transition if it’s crushed, and include a photo of the connection point in your job record.
- Bird and rodent entry through damaged Guardsman dampers. The flapper-style dampers on older Guardsman vent hoods stick open when lint glues them to the housing, which turns the vent into an open tunnel for birds, mice, and cold air. In every borough we see nests built inside the first four feet of the run. We remove the obstruction, install a bird guard where the termination allows, and test the damper’s pivot so it closes under its own weight.
- Restricted airflow from undersized Guardsman vent runs in renovated brownstones. When New York City brownstones get split into rental units, the dryer vent frequently gets re-routed through too many bends using Guardsman’s 4-inch components. A run with three elbows and 30 feet of pipe simply doesn’t move enough air at the blower’s rated static pressure. We measure the actual airflow at the termination, show you the numbers, and quote a re-routing or booster fan installation where the geometry allows. You’ll know exactly what the fix costs before we loosen a single clamp.
Our Guardsman Dryer Vent Cleaning Process

Every Guardsman job follows the same sequence, and the customer sees evidence at each step. Here’s what happens when you call:
- 1
Visual inspection of the dryer and vent termination. We start at the dryer, pull it out 18 to 24 inches, and inspect the transition hose, the wall elbow, and the termination cap. We’re checking for disconnects, crushed sections, and obvious blockages before we touch a single tool.
- 2
Camera inspection of the full run. A probe camera goes through the entire vent run, from dryer collar to outside termination. We record what’s inside and show you the footage. The photo tells you what’s in there - everything else is just paperwork.
- 3
Written scope and flat price. Based on the camera footage, we write out the scope: materials, labor, and the total price. This happens before any work begins, under Haven Standard Clause 1. You sign it, or we don’t start. The price doesn’t change after we begin unless you add work you asked for.
- 4
Negative-pressure extraction and mechanical agitation. We use a Rotobrush or Nikro system to agitate the interior walls while pulling air backward through the run with a HEPA-filtered negative-pressure unit (typically Abatement Technologies). This pulls the loosened lint out of the run rather than pushing it into the wall cavity.
- 5
Component replacement or repair. If the camera showed a failed cap, a crushed transition, or a stuck damper, we replace it now - with parts sized to Guardsman’s original vent dimensions. We’ll use Guardsman-brand components when they’re available and appropriate, and name the aftermarket part we’re using when an upgrade makes more sense. Either way, it’s on the written scope.
- 6
Post-cleaning camera verification and photo record. We run the camera through again, photograph every section that was dirty, and hand you the before-and-after photo record as part of your job file. The 365-Day Done Right Promise backs the work in writing, not on a postcard.
Before
AfterWhat Guardsman Dryer Vent Cleaning Costs in New York City
We don’t do per-vent pricing, and we don’t do $79 coupons that turn into $600 invoices once the van is parked. Every Guardsman vent cleaning gets one flat price, in writing, before work starts. Here’s what New York City homeowners can expect:
- Standard single-family Guardsman vent cleaning: $189-$249 for a straight run under 20 feet with one or two elbows. Includes full extraction, camera verification, and the photo record.
- Longer or multi-story runs (25-45 feet, three or more elbows): $269-$349. More bends mean more time with the agitation whip, and we quote accordingly.
- Vent cap or damper replacement during cleaning: $40-$95 added, depending on cap type and material, always quoted on the written scope.
- Full re-routing or booster fan installation: $450-$850, quoted only after airflow measurements and camera inspection. We’ll show you the numbers that justify the work and you decide.
Every estimate is free, and it’s delivered as a written scope - not a phone guess. Call (806) 606-6902 and we’ll schedule an inspection.
Why New York City Homeowners Call CleanRun Air Duct Cleaning for Guardsman Work

We’ve been at this since 2013, and we’ve documented every job with a photo record from the first one. Our technicians are background-checked, uniformed, and identified by name before they step inside - Haven Standard Clause 3. We work on Guardsman vent systems every week, but we also service Lennox, Trane, and Carrier dryer and HVAC venting, so we know how Guardsman components compare to what else is in New York City homes. The difference with us isn’t a slogan; it’s that you get a written price before we start and photographs of the inside of every run when we finish. If the work isn’t right, the 365-Day Done Right Promise puts that in writing too. Bring a competitor’s written estimate and we’ll put our number next to it in writing, free of charge.
FAQs
No. Cleaning the vent run is a maintenance procedure, not a modification to the dryer. What could void a warranty is operating the dryer with a blocked vent, which forces the blower motor to work against higher static pressure and the heating element to cycle hotter. When we replace components, we use parts that match Guardsman’s original dimensions - and we document the parts on your written scope, so you have a paper trail for any future warranty conversation.
A standard single-family vent cleaning takes 60 to 90 minutes on site, from door to door. Multi-story runs in brownstones or buildings with complex routing may take up to two hours. We quote time as part of the written scope, so you’ll know before we arrive.
Because they’re selling a visit, not a result. The typical pattern is a $49-$79 price to get a technician to your door, followed by upselling once the machine is pulled out and the vent is half-apart. Our price is written before any work starts and it doesn’t change. A cheaper price with a changeable scope costs more by the time the truck leaves. Call (806) 606-6902 and we’ll put our number in writing.
You’ll see it. Every CleanRun job includes a before-and-after photo record of the inside of your vent run, delivered with your job file. The camera doesn’t blur, and it doesn’t miss. If the photo shows a problem we didn’t fix, the 365-Day Done Right Promise covers it. In writing.
We do both. During the camera inspection we’ll assess the condition of every component in the run, and if the cap, damper, or transition hose needs replacement, we’ll line-item it on the written scope with a firm price. You approve it before we touch it. Many New York City vent terminations we see are original to the building and haven’t been replaced in 15 years or more - the dampers were never designed for that service life.
Schedule Your Guardsman Vent Inspection in New York City

If you own a Guardsman dryer or your building has Guardsman vent components, call us at (806) 606-6902. We’ll schedule a camera inspection, write out a flat price for the full scope of work, and hand you a documented photo record when we’re done. Written price first, every time - that’s the only way we work.
Written by Tomas Reyes, Owner & Lead Technician, CleanRun Air Duct Cleaning at CleanRun Air Duct Cleaning, serving New York City and nearby areas.




Before
After
Before
After