Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable HVAC Cleaning Across Fort Worth
HVAC cleaning in Fort Worth typically runs between $425 and $875 for a complete system, and the job usually takes four to six hours when it includes the evaporator coil, blower motor, air handler, and supply and return ducts. We serve every corner of Fort Worth, from the brick ranch belt of Wedgwood and Ridglea Hills to the older grids of Polytechnic Heights and Stop Six. If you’ve noticed dust settling back on furniture days after vacuuming, or a fine red grit around your return grilles, the answer probably sits inside your ductwork. Call (806) 606-6902 and we’ll put a written price in front of you before anyone touches a panel.
What makes Fort Worth different is the combination of extreme attic heat and Cross Timbers dust. We’ll get into the specifics below, because understanding why your system loads up faster than a Dallas or Arlington system matters when it comes time to decide what cleaning actually needs to happen. Our HVAC Cleaning team photographs every duct run before and after the work. You won’t be asked to trust a verbal summary.
Why CleanRun Air Duct Cleaning Is Fort Worth’s Preferred HVAC Cleaning Company
We don’t claim to be Fort Worth’s preferred company because a marketing team wrote it on a slide. We claim it because we document the work in a way that makes the claim easy to verify. Every job gets a written price before a single panel comes off, and every job ends with a photo record showing the inside of each duct run before and after. That’s Haven Standard Clause 1, and it has been how we’ve operated since 2013. No exceptions, no manager approval required.
Fort Worth homeowners tend to be skeptical, and we respect that. This is a market where $79 duct coupons have trained people to expect a bait-and-switch once the truck arrives. We answer that skepticism with a flat, whole-system price and a camera. You’ll see the 3-inch debris build-up at the first elbow in your return drop. You’ll see the disconnected flex collar in your attic. You’ll see the difference after extraction, in the same run, same angle, same register boot. That’s more persuasive than any review, but we’re glad to stand on those too: homeowners across Wedgwood, Hulen, and North Richland Hills have consistently rated us highly for thoroughness and written-price integrity. Crews are background-checked, uniformed, and identified by name before arrival, per Haven Standard Clause 3.
Tomas Reyes runs our Fort Worth scheduling and oversight. If something about a job needs to be made right, Tomas is the person who answers for it.
Our HVAC Cleaning Services in Fort Worth
HVAC cleaning is not one service. It’s a set of components that each fail differently in Fort Worth’s climate. Here’s what we clean and why each piece matters here specifically.
Evaporator Coil Cleaning
The evaporator coil sits inside your air handler and is the first place Fort Worth’s red-clay dust lands after it passes through your filter. Once the coil gets coated, the system loses cooling capacity and runs longer cycles, which pulls even more attic air through any duct gaps. In Fort Worth homes with 40-year-old ductwork, a dirty coil is often hiding a disconnected return boot somewhere upstream. We clean the coil with professional-grade equipment and inspect the full return path while we’re there.
Blower Cleaning
Blower motors in Fort Worth ranches work hard from May through September. A blower wheel caked with dust and clay particulate moves less air, raises static pressure, and shortens the motor’s life. We remove the blower assembly when accessible, clean the wheel and housing, and photograph the before and after. A clean blower on a properly sealed duct system restores airflow to rooms that have felt stuffy for years.
Air Handler Cleaning
The air handler is the box that houses the blower, evaporator coil, and often the filter. In attic-mounted systems common throughout Fort Worth’s 1960s-1980s housing stock, the air handler sits in the hottest part of the house all summer. That heat degrades seals and lets dust bypass the filter entirely. We clean the interior surfaces, check for gaps, and document every seam. When we find real problems, like disconnected flex duct or failed mastic, we tell you with photos in hand.
Condenser Cleaning
The outdoor condenser needs airflow across its fins. In Fort Worth, cottonwood seed, grass clippings, and that same fine clay dust build up on the coil by mid-summer. A restricted condenser drives head pressure up and cooling capacity down. We clean the fins with professional techniques that don’t bend them flat, and we’ll tell you if the unit’s location on the west or southwest wall of your house is making the problem worse.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Service in Fort Worth
We clean systems built around equipment from Honeywell, Aprilaire, and every major residential manufacturer, and we use professional extraction equipment from Rotobrush, Nikro, and Abatement Technologies on the job. We don’t use shop vacuums. We don’t use “negative pressure” as a marketing phrase while running a carpet cleaner hose into your register. When you book an HVAC cleaning in Fort Worth, the equipment roster is on the written estimate. You can look up what a Nikro or Rotobrush system actually is before you sign anything. We also stock common replacement components for Guardsman and Honeywell air quality accessories, which means fewer return trips when your cleaning reveals a filter housing or media cabinet that needs attention.
Common HVAC Cleaning Problems We See in Fort Worth Homes
- Disconnected flex duct at register boots in southside ranches. Wedgwood, Ridglea Hills, and Hulen were built out heavily in the 1970s and 1980s with attic-run flex duct. Decades of 145°F attic heat causes the plastic liner to harden and the connection at the boot to separate. Your system then pulls raw attic air, including fiberglass insulation fibers, straight into bedrooms. A camera inspection of every run is the only way to find this.
- Red-clay grit loading in return ducts. Fort Worth sits at the western edge of the Metroplex where prevailing winds off the Cross Timbers plains deliver fine red-clay particulate at higher concentrations than in Dallas or Arlington. This dust loads return ducts quickly and produces a distinctly gritty contamination mix. Standard cleaning without attention to return velocity leaves buildup that clogs filters within weeks.
- Sheet-metal trunk systems in pre-1950 neighborhoods. Polytechnic Heights, Riverside, and Stop Six contain many homes with original sheet-metal trunk-and-branch ductwork. These systems accumulate decades of debris and their access points are often in tight attic spaces or crawl areas. We photograph these runs carefully because every register opening is a documentable data point.
- Shared dryer vent stacks in apartment and condo buildings. In dense mid-rise buildings around Fort Worth, dryer vents often run through a shared stack. A single blocked lint pathway backs exhaust up into neighboring units. We coordinate with property managers to clean shared stacks correctly, because a partial clean of one unit’s portion doesn’t solve the building’s problem.
Pricing for HVAC Cleaning in Fort Worth, TX
A full HVAC cleaning in Fort Worth, covering the evaporator coil, blower, air handler, and all supply and return ducts, typically runs $425 to $875 depending on system size and number of duct runs. Evaporator coil cleaning alone runs $180 to $320. Blower cleaning alone runs $140 to $250. Air handler cleaning, including interior surfaces and accessible seams, runs $200 to $400. Condenser cleaning runs $110 to $220. These are the written prices you’ll see before work starts, and the price doesn’t change once we’re on site unless we find something structurally wrong and you approve an additional scope in writing first. If you have a competitor’s written estimate, bring it. We’ll put our number next to it, in writing, at no cost. Call (806) 606-6902 for your exact written quote.
We Also Serve Cities Near Fort Worth
Our crews serve Haltom City, North Richland Hills, Hurst, and Bedford, often within the same week as our Fort Worth appointments. If you’re in any of these communities and want the same written-price, photo-documented Fort Worth service, schedule through the same number. We dispatch from the Dallas-Fort Worth metro office and serve each city locally.
Serving Fort Worth, TX - Our Local Coverage Area
We’re based in the Fort Worth area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - HVAC Cleaning in Fort Worth
Fort Worth ranch homes built in the 1970s and 1980s were constructed with attic-run flexible ductwork that is now 40 to 60 years old and has been through thousands of thermal cycles at attic temperatures above 145°F. That heat hardens the flex liner and causes joints to separate, pulling attic air and fiberglass insulation particles directly into living spaces. Newer homes with rigid ductwork and better attic sealing simply don’t fail this way. Older Fort Worth systems need cleaning and inspection more often because the failure mode is structural, not just dusty. Call (806) 606-6902 and we’ll show you the difference with a camera.
Yes. We clean the blower wheel, air handler interior, and evaporator coil in place on the vast majority of Fort Worth jobs. Full removal is only needed when a component is so degraded that cleaning it in place would be pointless. On attic-mounted systems, our technicians work carefully in high-heat conditions and document every step with photos before and after.
In Fort Worth apartment and condo buildings with shared dryer vent stacks, a blockage in one unit’s lint pathway can back exhaust up into neighboring units. Cleaning just one unit’s portion doesn’t solve the problem, because the restriction is often in the common stack itself. We coordinate with property managers to clean the entire stack properly, and we provide photo documentation of every section we reach. If you’re a homeowner in a mid-rise Fort Worth building, we’ll tell you honestly whether your vent needs a unit-level or stack-level clean.
That red dust is fine clay particulate carried by prevailing westerly winds off the Cross Timbers plains west of Fort Worth. It enters your return air system at a higher concentration than in more sheltered parts of the Metroplex, and it’s gritty enough to clog filters within weeks. The dust isn’t a sign your system is broken, but it is a sign your return ducts are loading faster than standard cleaning cycles assume. Our cleaning protocol includes return-side velocity work specifically to address this Fort Worth condition. Call (806) 606-6902 to schedule an inspection with a written price.
Yes, and this is the most important part of the job on Fort Worth’s 1970s-80s ranch stock. We camera-inspect every accessible duct run, and we routinely find flex duct pulled completely free from register boots in Wedgwood and Ridglea Hills homes. When we find a disconnect, we document it with photos, show you the evidence, and quote the repair in writing before any additional work happens. A cleaning that skips this inspection leaves fiberglass blowing into bedrooms. We don’t skip it.
Call CleanRun Air Duct Cleaning in Fort Worth
We service a distinctive housing stock, and we work to a distinctive standard. Written price before work starts. Photo record of every duct run before and after. A 365-Day Done Right Promise in writing. If you’re in Fort Worth, Haltom City, North Richland Hills, Hurst, or Bedford, call (806) 606-6902 for a free written estimate. Tomas Reyes and the rest of the team will make sure you know exactly what you’re paying for before any work begins.
Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning, serving Fort Worth since 2013.
HVAC Cleaning in Nearby Areas
