Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable HVAC Cleaning Across Norwood
HVAC cleaning in Norwood, MA typically runs $380-$680 for a full system on a standard 1950s-60s ranch or Cape, and most jobs are completed in a single visit. The price depends on whether the system still carries oil-soot residue from a pre-conversion furnace, which requires a degreasing step many companies skip. If you’re noticing weak airflow, musty air at the registers, or dust settling on furniture within days of cleaning, the ductwork itself is likely the source. Call (806) 606-6902 and we’ll put a written price in front of you before any work begins.
Why CleanRun Air Duct Cleaning Is Norwood’s Preferred HVAC Cleaning Company
We’ve worked enough homes in Norwood to know what’s actually inside the duct runs here, and it’s not the same as what a newer-development crew finds in Canton or Needham. The post-WWII Capes and ranches off Nahatan Street, Nichols Street, and along Route 1A were framed around oil-fired forced-air furnaces, and the sheet-metal ductwork in many of those homes has never been fully cleaned since the day it was installed. That’s the work we do most often, and it’s the work we document with before-and-after photos of every run.
HVAC Cleaning for us means source removal: agitation tools that dislodge debris, HEPA-filtered negative-pressure extraction, and a camera inspection before and after so you can see what was actually removed. No shop-vac noise, no rushed pass through an undersized access panel. Every job in Norwood is quoted in writing before a single panel comes off, under Haven Standard Clause 1, and every job ends with a Documented Photo Record of the runs we serviced.
Our crews dispatch to Norwood from the brand’s Boston office, and we know the parking constraints on Washington Street, the narrow basements in the older homes near the town center, and the longer drive times to the outlying streets southwest of the high school. Tomas Reyes has been running this operation since 2013, and the standard has always been the same: written price first, photo record last, and a 365-Day Done Right Promise in between.
Our HVAC Cleaning Services in Norwood
Heat Exchanger Cleaning
In Norwood’s converted oil-to-gas furnaces, the heat exchanger often carries a baked-on film of oil combustion residue from the decades before conversion. This isn’t dust, and it doesn’t respond to a brush pass. Gas burns cleaner than oil, but the old residue remains until someone degreases it properly. We clean the exchanger with a dedicated degreasing step, then document the result with a camera. A dirty exchanger runs hotter and less efficiently; a clean one transfers heat the way the manufacturer intended.
Air Handler Cleaning
The air handler on older Norwood ranches sits in low-clearance basements where humidity from the Neponset watershed keeps surfaces damp for part of the year. We disassemble the access panels carefully, clean the blower wheel and housing, and treat the condensate path so the next season’s humidity doesn’t immediately undo the work. Rushed access through undersized panels is a known shortcut in this area’s tight basements; we don’t do it, and our photo record shows the sections most crews skip.
Evaporator Coil Cleaning
Norwood’s fall leaf cover and spring pollen load combine with basement moisture to coat evaporator coils in a paste that reduces cooling capacity by up to 30 percent on older systems. We clean coils with the same source-removal standard we use in the duct runs, using agitation tools and HEPA capture so dislodged material doesn’t blow back through the house. A clean coil also keeps the compress more stable during Norwood’s humid July weeks.
Coil Treatment
After cleaning, we apply a coil treatment in homes where the coil sits in the air stream year-round. This seals the cleaned surfaces against rapid re-soiling and microbial growth, which is particularly useful in Norwood basements that run damp from spring through early summer. The treatment is included in the written scope when we determine it’s needed during the inspection, not added on as a surprise line item.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Service in Norwood
Most Norwood homes we service use equipment from Honeywell, Carrier, or Trane, with Aprilaire accessories common on newer retrofits. Our technicians work on all brands, and the cleaning equipment we bring in is Rotobrush and Nikro, which means the agitation and extraction are done to professional standard. If you’re checking our work against manufacturer service guidelines, you’ll find we meet or exceed them. We also carry common Guardsman and Honeywell replacement parts in our vans, so a filter housing or access latch issue doesn’t become a second appointment.
Common HVAC Cleaning Problems We See in Norwood Homes
- Oil-soot residue from pre-2000 furnaces. Norwood’s oil-to-gas conversion wave left a coating on the plenum and heat exchanger that standard brush passes don’t dislodge. Without a degreasing step, the residue re-contaminates cleaned ducts within months.
- Undersized access panels in 1950s-60s ranches. Low basement clearances lead some crews to work through panels too small to reach the full return side. Sections get skipped, and the homeowner never sees it because no one shows them the camera footage.
- Mold in un-insulated metal ducts. Above-average basement humidity from Norwood’s position in the Neponset watershed creates condensation on bare sheet metal during shoulder seasons. Ducts then harbor microbial growth that cleaning companies treating only visible dust never address.
- Dust and pollen from unpaved roads and open land. Homes on the outskirts of Norwood, especially near the Stoughton and Canton lines, pull in road dust from unpaved shoulders and agricultural pollen that settles into return ducts and clogs the blower wheel over a single season.
Pricing for HVAC Cleaning in Norwood, MA
A full HVAC cleaning in Norwood for a typical ranch or Cape runs $380-$680, depending on the number of return drops and whether a degreasing step is required. Coil cleaning alone on an accessible evaporator typically runs $180-$260. Air handlers with heavy blower buildup or microbial growth run $220-$340. Heat exchanger degreasing on a converted oil-to-gas furnace adds $140-$200 to the total, and we always confirm this from inspection before including it in the written scope. There is no per-vent pricing, no lowball coupon, and no surprise upcharge when the tech arrives. The price we write down before touching your system is the price on the invoice.
We Also Serve Cities Near Norwood
Our crews cover HVAC Cleaning in Norwood and the surrounding towns including Canton, Dedham, Stoughton, and Needham. If you’re just outside the Norwood line, call us and we’ll schedule directly. The same written price, photo record, and 365-Day Done Right Promise apply to every job, regardless of town.
Serving Norwood, MA - Our Local Coverage Area
We’re based in the Norwood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - HVAC Cleaning in Norwood
Because the original oil-burning furnace left a thin, baked-on soot film inside the plenum and across the heat exchanger, and that film doesn’t come off with a brush pass. Gas burns cleaner, but the old residue stays until someone degreases it properly. In Norwood’s post-WWII housing stock, we find this on the majority of homes built before 1980 that converted to gas after 2000. Skipping the step means the cleaned ducts get re-contaminated within one heating season. Call (806) 606-6902 and we’ll camera-inspect your plenum before quoting, so you know what’s actually in there.
Every 4 to 6 years is a realistic interval for most Norwood homes, though houses near unpaved road edges or with standout pollen exposure may benefit from every 3 years. The 1950s-70s stock has original sheet-metal ductwork that wasn’t designed for tight modern filtration, so debris accumulates faster than in newer systems. After the first proper source-removal cleaning with a degreasing step, you may find the interval can stretch to the longer end. Call (806) 606-6902 and we’ll give you a written recommendation based on what the camera shows, not a calendar.
Yes. Norwood’s original galvanized sheet-metal ducts are generally robust in the straight runs, with the weak points at joints and elbows where decades of screws and tape patches have left thin spots. We use low-impact agitation tools, not aggressive beaters, and we inspect suspect joints with a camera before applying pressure. The photo record we give you afterward shows the interior of each run, so you can verify the metal is intact and the debris is gone. Call (806) 606-6902 to schedule an inspection.
Yes, directly. Norwood sits within the Neponset River watershed and many basements run damp from spring into early summer. That moisture gets pulled into the air handler, settles on the blower wheel, and creates a sticky film that attracts dust and reduces motor efficiency. On our jobs around Nichols Street and the surrounding ranch neighborhoods, we regularly find blower wheels that have never been cleaned and are running at reduced airflow as a result. We clean the wheel, housing, and condensate path, and the photo record shows the difference. Call (806) 606-6902 for a written estimate.
The most direct fix is improving the return-side filtration and making sure the return ducts are properly sealed, because dust from unpaved road edges and open land gets pulled into the return side and circulated through the blower and coils. We find this consistently on homes near the Stoughton and Canton lines, where road dust loading is higher than in the town center. A clearly documented cleaning of the return runs, followed by the right filter upgrade for your system, cuts the dust resettlement noticeably. Call (806) 606-6902 and we’ll walk through the options in writing.
Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning, serving Norwood since 2013.