Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable HVAC Cleaning Across Madera
HVAC cleaning in Madera costs between $425 and $890 for a full system clean in a typical 1,800 to 2,600 square foot home, and most jobs take four to six hours. That is the honest range we quote before a single register comes off. If you live off Cleveland Avenue, up near the Ranchos, or anywhere else in Madera where harvest dust loads the air every fall, we can put that number in writing before work begins. Call (806) 606-6902 and you’ll get a written price, not a sales pitch.
We coordinate our Madera scheduling from our Central Valley office in Fresno, so a crew can be at your door without the delays of a far-away dispatch. We know the streets, the soil, and what the almond orchards on the county’s east side do to a coil by late October.
Why CleanRun Air Duct Cleaning Is Madera’s Preferred HVAC Cleaning Company
CleanRun has built its name in Madera on something most HVAC companies never hand over: a Documented Photo Record of every duct run, before and after. You don’t take our word that the evaporator coil was caked in three inches of harvest dust. You get the photos. That practice started with our first job in 2013 and it has not changed across the 52,000+ homes we’ve served since.
Every Madera job follows Haven Standard Clause 1: a written price before any work starts. No exceptions. No “we’ll see what we find and call you back.” Tomas Reyes, our owner, made that rule non-negotiable because Madera homeowners told him exactly what they feared most: the bait-and-switch. If a competitor hands you a written estimate, bring it in. We’ll put our own number next to it, in writing, for free under our Second Opinion policy.
Crews arrive uniformed, background-checked, and identified by name before stepping onto your property. That’s Haven Standard Clause 3, and it’s printed in the job record you receive when the crew leaves. Madera homeowners routinely tell us the difference is obvious within the first ten minutes.
Our HVAC Cleaning Services in Madera
We clean the entire air path, not just the registers you can see. In Madera, the work usually starts at the return side and follows the air exactly where it flows: through the blower, across the evaporator coil, and out every supply run to the registers. Here’s what that includes.
Evaporator Coil Cleaning
The evaporator coil is the cold surface inside your air handler that pulls heat and humidity out of Madera’s valley air. After one almond harvest, that coil can look like it’s wearing a felt blanket. We remove it with a professional-grade Nikro coil cleaner and follow with a rinse that drains into your condensate pan, not onto your attic floor. A clean coil in Madera means your AC pulls the same amperage in September that it did in April, without working harder every month.
Air Handler Cleaning
Your air handler is the metal box that houses the blower, the coil, and often the filter. In Madera homes built in the 1990s and 2000s, those handlers sit in attics that hit 150°F from June through September. Dust bakes onto the blower wheel fins and throws the whole assembly out of balance. We pull the blower, brush and vacuum the wheel, and send a camera through the handler cabinet before we put it back. The before-and-after photos are yours to keep.
Blower Cleaning
A blower wheel coated in valley dust moves less air and draws more current. It’s simple physics, and it’s the most common cause of premature blower motor failure we see in Madera. We remove the wheel, clean it with a Guardsman brush kit and compressed air, and reinstall it with balanced operation confirmed by hand-spin and amp draw. If the wheel is caked enough, we’ll tell you before we touch it, with a written price for the full clean attached.
Condenser Cleaning
The condenser is the outdoor unit, and in Madera it faces a relentless assault: field dust, pollen, cottonwood fluff, grass clippings, and the fine grit that blows off bare orchard soil. We shut the system down, wash the coil fins from the inside out with a low-pressure rinse, and clear the base pan and drain holes. We don’t pressure-wash. High-pressure water folds the fins flat and kills airflow permanently. If you want proof of what was collected, our photo record covers the outdoor unit too.
Coil Treatment
After cleaning, we can apply a coil treatment that slows the re-adhesion of dust to the evaporator surfaces. In Madera’s harvest months, untreated coils re-coat in weeks because the air carries so much agricultural particulate. A treatment isn’t a permanent force field and we won’t sell it as one. It’s a hydrophobic coating that makes the next cleaning easier and extends the interval. Honest description, written price, same as everything else we do.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Service in Madera
Whether your system was installed in a 1960s ranch near downtown or a 2005 spec home off Avenue 12, CleanRun technicians arrive equipped for the brands found in Madera’s housing stock. We work with equipment from Honeywell, Aprilaire, and Abatement Technologies, and we stock the filters and coil cleaners matched to those systems. Our crews carry Rotobrush and Nikro gear calibrated for flex-duct and sheet-metal runs alike. That means a cleaner that fits your house, not whatever was left on the truck.
Common HVAC Cleaning Problems We See in Madera Homes
- Harvest dust and Tule fog combine into sludge. The fine dust from almond and grape harvests doesn’t just sit in your ducts. When winter Tule fog pushes humidity up for weeks, that dust absorbs moisture and turns into a paste that hardens inside flex-duct sag points by November. Once it hardens, it feeds mold and chokes airflow. Cleaning in October or early November removes the paste before it cures.
- Attic flex-duct joints separate in 150°F heat. Madera’s summer attic temperatures cause flex duct to sag and pull away at joints just past the air handler. When that gap opens, the system pulls fiberglass insulation and rodent waste straight into the supply side. You don’t see it until a musty smell fills the hall or the blower motor burns out. Our camera inspection catches the separation before the motor does.
- Builder-grade filters clog in two weeks during almond harvest. A 1-inch pleated filter in a Madera home near the orchards can be completely blindsided by October. When it clogs, the homeowner often removes it or replaces it with a cheap fiberglass sheet, and the AC runs unfiltered for months. Valley particulate then bakes directly onto the coil fins and duct walls, which is exactly the problem a full clean addresses.
- Decades-old sheet metal runs near downtown Madera go uncleaned. The 1960s and 1970s homes around downtown often have sheet-metal duct runs that have never been opened. The interior holds thirty or forty years of greasy bonded dust, which the Tule fog humidity reactivates into odor each winter. Our Rotobrush system with HEPA filtration removes what homeowners assume is permanent.
Pricing for HVAC Cleaning in Madera, CA
Here’s how pricing breaks down in Madera. A full HVAC cleaning covering the air handler, blower, evaporator coil, and accessible supply/return runs typically runs $425 to $890 depending on square footage, number of runs, and system accessibility. Condenser-only cleaning runs $150 to $250. Evaporator coil cleaning alone runs $200 to $350. Add-on coil treatment runs $95 to $180 depending on coil size. If you live in a larger home in the Ranchos or have a dual-system setup, expect the higher end of each range. The exact number appears on a written quote before any work starts. Call (806) 606-6902 and we’ll put it in writing.
| Service | Madera Market Range |
|---|---|
| Full HVAC Cleaning (air handler + blower + coil + accessible runs) | $425 - $890 |
| Evaporator Coil Cleaning (standalone) | $200 - $350 |
| Condenser Cleaning (standalone) | $150 - $250 |
| Coil Treatment (add-on) | $95 - $180 |
We Also Serve Cities Near Madera
CleanRun’s crews cover the full Central Valley corridor around Madera, including Fresno, Clovis, Sanger, and Selma. If you’re in any of those cities and dealing with the same valley dust and attic heat we see here, our HVAC Cleaning process is identical. Same written pricing, same photo record, same 365-day guarantee. This page keeps growing, and you can read more about what we do across the region at our HVAC Cleaning in Madera page.
Serving Madera, CA - Our Local Coverage Area
We’re based in the Madera area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - HVAC Cleaning in Madera
Musty ducts during Tule fog happen because the fog pushes indoor humidity high enough to re-wet accumulated dust and organic debris inside the ductwork, which activates dormant mold spores. In Madera, this season runs from November through February, and homes with flex-duct sag points or years of un-cleaned sheet-metal runs are the ones that smell first. The fix is source removal of the debris that holds the moisture, not masking with a spray. Call (806) 606-6902 for a written quote on a full clean.
A Madera home within a mile of almond orchards should get HVAC cleaning every 12 to 18 months, with a coil inspection every fall right after harvest. Homes further from agricultural land, or those with high-efficiency filters running year-round, can stretch to 24 months. But if your 1-inch filter clogs in under two weeks during October, you’re in the 12-month group and likely need a post-harvest cleaning every year. Call (806) 606-6902 and we’ll help you figure out where your house falls.
No. A fogging sanitizer kills a limited number of surface spores, but it does not remove the organic material the mold feeds on. In Madera, that material is the harvest dust and Tule fog moisture paste that lines flex-duct sag points and sheet-metal runs. Within weeks in the same humidity conditions, the mold returns. Source removal, meaning physically extracting the debris and moisture-trapping buildup, is the only fix worth paying for. That’s what our Rotobrush and HEPA filtration system does, and you get before-and-after photos to verify it happened. Call (806) 606-6902 for a written quote.
First, don’t run the AC with no filter, and don’t substitute a fiberglass panel that lets dust through. In Madera’s harvest season, that dust bakes directly onto your evaporator coil and blower wheel, which turns a simple filter change into a $400 coil cleaning later. Second, upgrade to a higher-MERV filter rated 8 or above for the harvest months, and check it weekly until the dust settles. Third, schedule a post-harvest duct inspection while the debris is still loose, before the Tule fog turns it into sludge. Call (806) 606-6902 and we’ll schedule it for the week the harvest ends.
Yes, and in Madera it’s one of the most common causes of hidden duct failure. Attics in Madera homes routinely exceed 150°F from June through September, which softens flex duct and causes it to sag and separate at joints. Those gaps pull attic insulation, rodent waste, and dust directly into your supply side. In a 2003-built subdivision off Avenue 12 near the Madera Golf Course, our tech found exactly that: a flex-duct run separated just past the air handler, pulling fiberglass into the supply registers. We removed the debris with negative pressure and a Rotobrush, then resealed the joint. If you haven’t had an attic duct inspection in the past three years, call (806) 606-6902 and we’ll put one on the schedule.
Call CleanRun for Honest HVAC Cleaning in Madera
Every job gets a written price before work begins. Every duct run gets photographed before and after. Every job is backed by the 365-Day Done Right Promise. If the work is not right, we make it right. That guarantee is in writing on every job record, not just on this page. If you’re in Madera and you want evidence-based HVAC cleaning from a company that shows you the work, call (806) 606-6902. Tomas Reyes and his team will answer.
Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning, serving Madera since 2013.
HVAC Cleaning in Nearby Areas
