Air Duct Cleaning in Tigard - One Flat Price, Before-and-After Photos

Air Duct Cleaning in Tigard, OR

Dryer vent cleaning in Tigard is a job shaped by the city’s housing stock: most single-family homes went up between 1970 and the early 1990s, which means original vent runs that are now 30 to 50 years old and rarely routed to current code. Add Tigard’s seven-plus months of cool, damp Tualatin Valley air from October through May, and lint that would otherwise blow through a short vent instead hangs in a long, kinked run and traps moisture. The result is a measurable airflow restriction and, in too many cases, condensation that turns packed lint into a dense, damp mat. If your dryer takes two cycles to finish a load, call (806) 606-6902 and we’ll send a background-checked technician with a written price before any work starts.

Call (806) 606-6902

Why Tigard Homes Are Different

Tigard’s build-out accelerated along the Highway 217 corridor after Washington Square opened, and the ranch-style and split-level homes from that era share a common ductwork profile: fiberglass-lined sheet metal trunks, early flex duct that has sagged or separated at the joints, and long vent runs that were installed before modern sealing standards existed. On the home side of the work, we rarely find a 1970s Tigard house whose original ductwork has been fully replaced. The Fanno Creek corridor through neighborhoods like Metzger adds a second factor: localized ground moisture that increases condensation risk inside poorly insulated supply runs. When heating season begins, that damp interior is exactly where mold and bio-film establish themselves. Homes on Bull Mountain, annexed into Tigard in the 2000s and built with more current materials, still warrant inspection because Oregon’s persistent humidity works on every system, regardless of install year.

Our Main Tigard Services

The two services Tigard homeowners call about most are full-system air duct cleaning and HVAC cleaning, both of which handle the ductwork, plenums, and mechanicals that move air through the house. Here’s how each works in Tigard specifically.

Air Duct Cleaning in Tigard

Full-system Air Duct Cleaning in Tigard uses negative-pressure extraction to pull dust, debris, and what the camera finds back out of the supply and return runs without blowing it into your living space. On a 1970s ranch in the Metzger area, the camera often shows a 2- to 3-inch debris build-up at the first elbow behind the furnace, plus degraded fiberglass liner in the main trunk. We photograph every run before and after and hand you the photo record as part of the job.

HVAC Cleaning in Tigard

HVAC Cleaning in Tigard goes beyond the duct runs to the equipment itself: the blower fan, evaporator coil, drain pan, and condenser. In a Tigard home running heat for seven straight months, a coil caked with dust and pet hair reduces airflow at the source, which means the ductwork stays cleaner but the system still underperforms. We clean the mechanicals with professional-grade equipment from Abatement Technologies and Rotobrush, then verify the work with before and after photos of each component.

Before

After

Dryer Vent Cleaning in Tigard

Dryer vent cleaning in Tigard addresses the single most common source of dryer inefficiency we see in the city’s 1970s through early 1990s housing stock: long vent runs, often 15 to 25 feet from dryer to exterior, with multiple elbows and original foil flex that has sagged, kinked, or torn at a joint. Add Oregon’s seven-plus months of damp, cool air, and lint that would otherwise flow out of a short vent instead accumulates at every bend, traps moisture, and compacts into a dense mat that reduces airflow and, in the Tualatin Valley’s bowl climate, promotes mold growth inside the run. Our Dryer Vent Cleaning service includes a full camera inspection of the run before we touch anything, so you see exactly what we found and what we removed.

Dryer Vent Inspection

Signs you need it

Your dryer takes two or three cycles to dry a normal load, the exterior vent flap barely opens while the dryer runs, or you smell a musty odor near the dryer that gets stronger during use.

What it costs in Tigard

A standalone dryer vent inspection in Tigard typically runs $95-$145, and the price includes a full camera record of the inside of the vent run.

How we do it

We snake a high-resolution camera through the entire run from dryer to exterior termination, photograph every elbow and joint, and write up what the footage shows before recommending any cleaning or repair.

Lint Removal

Signs you need it

You see lint accumulating around the dryer drum or floor despite a clean lint trap, the dryer runs hot to the touch, or the vent flap sticks partially open.

What it costs in Tigard

Full lint removal from the vent run in a Tigard home typically costs $120-$190, depending on run length and how compacted the lint has become.

How we do it

We use a rotary brush system with HEPA-filtered negative-pressure extraction to loosen and pull out the packed lint, then run the camera back through to confirm the run is clear and photograph the result.

Vent Rerouting

Signs you need it

Your current vent run exceeds 35 feet in equivalent length, has more than three elbows, or terminates into a crawlspace or attic instead of directly outside.

What it costs in Tigard

Rerouting a dryer vent in Tigard typically runs $280-$500 depending on the new route, the number of elbows, and whether roof termination is required.

How we do it

We map the shortest code-compliant route with rigid metal duct, replace any sections of foil flex, and seal every joint with aluminum tape so the run stays smooth and airtight.

Bird Guard Installation

Signs you need it

You hear birds or scratching near the roof vent, see nesting material poking out from the termination, or find an active nest in or around the vent opening.

What it costs in Tigard

A bird guard installed on a Tigard dryer vent termination typically costs $60-$110 including the guard and installation.

How we do it

We remove any nesting material, clean the termination, and install a purpose-built screen guard that keeps birds out while maintaining full airflow.

What Dryer Vent Cleaning Costs in Tigard

Long runs, roof terminations, and compacted lint that has hardened from moisture all push the number up. Every quote is a written price delivered before work starts, and under Haven Standard Clause 1 you’ll know the exact dollar amount before a single panel comes off.

How often should I clean my dryer vent in Tigard?

In Tigard, most homes should clean the dryer vent every 12 to 18 months. The damp Tualatin Valley climate and long, elbow-heavy runs in older homes mean lint accumulates faster than in drier regions, and a clogged vent adds drying time and fire risk. Call (806) 606-6902 to schedule yours.

Can you clean a dryer vent that vents through the roof?

Yes, roof-terminated vents are common in Tigard’s ranch and split-level homes, and we clean them regularly. The camera inspection shows us exactly where the build-up is, and our rotary brush handles the vertical rise without pushing debris into the attic. Written price first, always.

Duct Repair & Sealing in Tigard

Duct repair and sealing in Tigard tackles what decades of heating-season cycles do to original ductwork: joints that have separated, flex runs that sag between supports, and sheet metal trunks with rust or punctures. In a 1970s Tigard home, the supply run from the furnace to the far bedroom often leaks 20 to 30 percent of conditioned air into the crawlspace before it reaches the register. That leaked air is paid for twice, once in the gas or electric bill and once in rooms that never quite warm up. Our Duct Repair & Sealing service finds every leak, photographs it, and seals it with materials that match the duct type, not a one-size spray that fails in a year.

Duct Sealing

Signs you need it

Rooms at the far end of the house stay cold while rooms near the furnace are warm, your energy bill climbs year over year, or you can feel air escaping at visible joints in the crawlspace or basement.

What it costs in Tigard

Whole-system duct sealing in a typical Tigard home ranges $380-$650 depending on access and the number of accessible joints and seams.

How we do it

We locate leaks with a pressure test, photograph each one, then apply fiber-reinforced mastic and aluminum tape to every leaking seam and joint so the system holds pressure when we retest it.

Flex Duct Repair

Signs you need it

You see sagging or kinked flex runs in the crawlspace or attic, a room that used to heat well now stays cold, or the flex duct has torn at the connection to a metal boot.

What it costs in Tigard

Repairing or replacing a damaged flex run in Tigard typically runs $160-$300 per run, depending on length, diameter, and accessibility.

How we do it

We replace collapsed or torn flex with properly sized R-6 insulated flex, stretch the run snug between supports, and seal both ends with mastic so the connection cannot leak air.

Metal Duct Repair

Signs you need it

You see rust spots, dents, or punctures in the sheet metal trunk line, or the camera inspection shows separation at a longitudinal seam inside the duct.

What it costs in Tigard

Sectional metal duct repair in Tigard typically runs $200-$420 depending on the size of the affected section and crawlspace or attic access.

How we do it

We cut out the damaged section, fit and fasten a new sheet metal replacement, seal every seam with mastic, and photograph the finished work so you can see the difference.

What Duct Repair & Sealing Costs in Tigard

Crawlspace depth, the number of runs, and whether we need to open a finished ceiling to reach a damaged section all move the number. You get a written price with a full scope of work before anything is opened.

Do I need a permit to repair ductwork in Tigard?

For repair and sealing work, no permit is required in Tigard. If the job expands into a full mechanical replacement, which is rare on a repair call, Washington County permitting rules apply and we’ll walk you through that process. We never start work without you knowing exactly what’s involved.

Why do my ducts leak in the first place?

Age, material failure, and original installation standards. Tigard homes built in the 1970s through early 1990s often used foil tape that dries and fails over decades, plus early flex duct that sags between supports and separates at the joints. The fix is straightforward once we find the leaks.

Air Quality & Sanitizing in Tigard

Air quality and sanitizing in Tigard addresses what seven-plus months of cool, damp air does inside ductwork: condensation along poorly insulated runs, especially through the Fanno Creek corridor and the Metzger area, creates conditions where mold spores, bacteria, and odor sources establish themselves inside the system. Once established, those contaminants move through supply registers every time the furnace cycles, which means the problem is distributed room by room. Our Air Quality & Sanitizing service starts with a camera inspection to identify what’s actually present, then treats the ducts and components with solutions matched to the finding, followed by before and after photographs so the result is documented, not asserted.

Mold Treatment

Signs you need it

You see visible mold growth on supply registers or inside the plenum, smell a persistent musty odor from the vents, or have recurring allergy symptoms that improve away from home.

What it costs in Tigard

Mold treatment for ductwork in Tigard typically runs $350-$700 depending on the extent of the growth and the footage of the affected runs.

How we do it

We photograph the affected surfaces, treat them with an EPA-registered antimicrobial, then run a full dry-out cycle to remove the moisture that allowed the growth in the first place.

UV Light Installation

Signs you need it

You’ve had repeated mold growth on the evaporator coil, a household member has a respiratory condition worsened by indoor air, or the coil area stays damp year-round.

What it costs in Tigard

UV light installation in a Tigard HVAC system typically costs $450-$800 including the fixture, bulb, and wiring to the blower circuit.

How we do it

We mount a manufacturer-specified UV-C fixture in the supply plenum or over the coil, wire it so it runs only when the blower runs, and verify placement with a photo after install.

Odor Removal

Signs you need it

You smell smoke, cooking oil, pet odor, or a stale locker-room smell from the supply registers every time the furnace starts.

What it costs in Tigard

Whole-system odor removal in Tigard typically costs $250-$450 depending on the source and whether additional cleaning is required first.

How we do it

We identify the odor source with the camera, clean the surfaces where odor particles have bonded, then treat with a neutralizing agent designed for porous duct materials and install Guardsman filters where specified.

What Air Quality & Sanitizing Costs in Tigard

What’s actually present drives the final number: mold that has spread into the trunk line costs more to treat than a single localized patch. You’ll know the written price before any treatment begins.

Can you sanitize ducts without cleaning them first?

No, and we won’t. Sanitizing over a layer of dust and debris means the treatment cannot reach the surfaces where mold and bacteria live, and the result is a false sense of completion. We clean first, photograph the inside, then treat. Call (806) 606-6902 and we’ll walk you through the sequence.

Is duct mold a real problem in Tigard?

Yes, and it’s tied directly to the Tualatin Valley’s damp season. Condensation inside poorly insulated runs is common from October through May, especially near the Fanno Creek corridor, and that moisture plus years of organic dust creates the conditions mold needs. If you see it, treat it early.

Brands We Service in Tigard

We work with and install equipment from Honeywell, Aprilaire, Abatement Technologies, and Guardsman, with common replacement parts stocked for Tigard jobs. Most installations and parts replacements are completed the same day we diagnose the need. Visit our brands page for the full list and manufacturer specs.

Pricing for Air Duct Cleaning in Tigard, OR

Neighborhoods We Serve in Tigard

Our crews serve every Tigard neighborhood, from the 1970s ranch homes along the Fanno Creek corridor to the newer construction on Bull Mountain and the Summerfield planned community along SW Durham Road. We carry the same written-price standard and documented photo record on every job, regardless of where in Tigard the home sits.

• Metzger
• Summerfield
• Bull Mountain
• North Tigard
• Downtown Tigard

Typical scheduling for a Tigard appointment runs 1 to 3 business days out, and we always confirm the tech’s name before arrival.

Service Area - Cities Near Tigard

Our crews serve Tigard and the surrounding metro. We regularly work in Portland, OR, Gresham, OR, Hillsboro, OR, and Beaverton, OR, with the same written-price and photo-record standard on every one of those jobs. If your home is within 30 minutes of Tigard, call us and we’ll tell you honestly whether we can fit you in.

FAQs About Air Duct Cleaning in Tigard